kaboodle hack: cut-out support rails

Kaboodle
By Kaboodle

An alternate set-up hack that's great for sinks and cooktops!

kaboodle hack: cut-out support rails

When installing sinks and cooktops, you'll generally have to cut through not only the benchtop, but also the support rail of the cabinet directly below.

One way of avoiding this is to rotate the support rail to a vertical position prior to installing the cabinet.

How to do it yourself

Simply mark a line 8mm back from the front edge of each side panel. Using a countersinking 4mm bit, pre-drill 2 holes; 24mm & 56mm down from the top of the cabinet. These holes should line up with the pre-drilled holes in the support rail which you can then screw into place using the screws provided.

DIY level - Beginner

You may also like